Add some checks that seem logically necessary, in particular let's make
real sure that HS slave sessions cannot create temp tables. (If they did
they would think that temp tables belonging to the master's session with
the same BackendId were theirs. We *must* not allow myTempNamespace to
become set in a slave session.)
Change setval() and nextval() so that they are only allowed on temp sequences
in a read-only transaction. This seems consistent with what we allow for
table modifications in read-only transactions. Since an HS slave can't have a
temp sequence, this also provides a nicer cure for the setval PANIC reported
by Erik Rijkers.
Make the error messages more uniform, and have them mention the specific
command being complained of. This seems worth the trifling amount of extra
code, since people are likely to see such messages a lot more than before.
we're not going to support that anymore.
I did keep the 64-bit-CRC-with-32-bit-arithmetic code, since it has a
performance excuse to live. It's a bit moot since that's all ifdef'd
out, of course.
Enabled by recovery_connections = on (default) and forcing archive recovery using a recovery.conf. Recovery processing now emulates the original transactions as they are replayed, providing full locking and MVCC behaviour for read only queries. Recovery must enter consistent state before connections are allowed, so there is a delay, typically short, before connections succeed. Replay of recovering transactions can conflict and in some cases deadlock with queries during recovery; these result in query cancellation after max_standby_delay seconds have expired. Infrastructure changes have minor effects on normal running, though introduce four new types of WAL record.
New test mode "make standbycheck" allows regression tests of static command behaviour on a standby server while in recovery. Typical and extreme dynamic behaviours have been checked via code inspection and manual testing. Few port specific behaviours have been utilised, though primary testing has been on Linux only so far.
This commit is the basic patch. Additional changes will follow in this release to enhance some aspects of behaviour, notably improved handling of conflicts, deadlock detection and query cancellation. Changes to VACUUM FULL are also required.
Simon Riggs, with significant and lengthy review by Heikki Linnakangas, including streamlined redesign of snapshot creation and two-phase commit.
Important contributions from Florian Pflug, Mark Kirkwood, Merlin Moncure, Greg Stark, Gianni Ciolli, Gabriele Bartolini, Hannu Krosing, Robert Haas, Tatsuo Ishii, Hiroyuki Yamada plus support and feedback from many other community members.
There are two ways to track a snapshot: there's the "registered" list, which
is used for arbitrary long-lived snapshots; and there's the "active stack",
which is used for the snapshot that is considered "active" at any time.
This also allows users of snapshots to stop worrying about snapshot memory
allocation and freeing, and about using PG_TRY blocks around ActiveSnapshot
assignment. This is all done automatically now.
As a consequence, this allows us to reset MyProc->xmin when there are no
more snapshots registered in the current backend, reducing the impact that
long-running transactions have on VACUUM.
snapmgmt.c file for the former. The header files have also been reorganized
in three parts: the most basic snapshot definitions are now in a new file
snapshot.h, and the also new snapmgmt.h keeps the definitions for snapmgmt.c.
tqual.h has been reduced to the bare minimum.
This patch is just a first step towards managing live snapshots within a
transaction; there is no functionality change.
Per my proposal to pgsql-patches on 20080318191940.GB27458@alvh.no-ip.org and
subsequent discussion.
